INCRA Router Table Routing Template
There's a lot of value the convenience, economy, and performance of a good commercially-made router table, but if you want to build a table or have a custom router installation in mind, this routing template will save you tons of time.
This 3/4"- thick MDF template is machined on computerized equipment to produce a perfect fitting table opening for 9-1/4" x 11-3/4" INCRA router lifts and router mounting plates.The generous border allows it to be clamped into position on all but the largest router tables, and there's plenty of surface area for double-sided tape, if you prefer.
Note: This template will not work for the 8-1/4" wide plate of the Rockler/INCRA Mast-R-Lift II.
A pattern router bit (bearing on the shank) with a cutting length of 1/2" to 3/4" is ideal for use with this template, and the Whiteside K-41 bit is ideal.
Whiteside #K-41 Pattern Routing Bit
This top-quality pattern bit has the pilot bearing on its 1/4" shank. The short 1/2" cutting length is much shorter than most pattern bits, allowing it to fit places others won't. Ideal for routing table openings with the INCRA Router Table Routing Template.