Now available in imperial or metric!
This is a perfect all-around system for smaller shops looking for thousandth-of-an-inch accuracy and repeatability for both table saw ripping work AND routing operations using a right-side router table.
The 32" or 810mm capacity TS-LS rip fence system is combined with a complete package of the routing accessories used in the dedicated LS Router Table Systems.
The 28" x 32" right-side router table (32" x 32" on the XL version) replaces the saw’s original right-side extension wing and neatly fills the space between the rails. The router location allows 5” – 6” fence travel for routing work without moving the fence system's base assembly on the rails, and the fence system can be reversed on the rails for more routing capacity.
Support Legs for the INCRA TS main rails highly recommended to ensure the table saw's stability.
See compatibility info below.
Compatibility:
Choose Standard or XL:
The standard TS Combo #2 covers saws measuring 27” to 28” front-to-rear along the miter slot. The XL version accommodates saws measuring 30" to 31" deep along the miter slot.
Right-side Router Tables:
Because TS Combo #2’s router table replaces the table saw's original right-side cast iron extension wing, saws that have a motor housing protruding from the right side of the cabinet have potential interference with the router below the table.
Basic requirements for ALL table saws:
The saw’s top must have flat, vertical surfaces on both the front and rear for the (4) adjustable INCRA rail mounting brackets to bolt against – 2 brackets at the front and 2 on the rear.
The brackets are attached with a minimum 5/16”-18 or 8mm bolt. Due to a lack of standardization, some metric table saws will require the user to supply 4 to 6 common bolts for rail installation. The bolt holes need to be centered between 3/4” and 1-3/8” down from the saw’s top surface, with enough clearance underneath the saw’s top for the washers, nuts and wrench (if the holes aren’t threaded).
The General Compatibility Chart lists the various categories of saws, and the TS-LS owner's manual is the best resource for seeing how the 4 rail mounting brackets attach for comparison with your saw.

Made in USA.
Popular accessories & upgrades:
|
INCRA TS Rail Support Legs
The INCRA Table Saw Rail Support Legs directly support the rails of the TS-LS, TS-III, and TS-II Systems, adding stability to the entire saw platform.
|
|
INCRA CleanSweep Dust Collection Combo
Keeps your shop cleaner by collecting sawdust at the source using your 4" dust collector! This complete combo includes the CleanSweep Cabinet, 6-pc set of CleanSweep MagnaLOCK rings, and the CleanSweep Guide Bushing Ring.
|
 |
Router Bits
Top quality Whiteside router bits are the perfect complement to the accuracy of an INCRA System. For dovetails & box joints, check out the #605 or #610 sets.
|
 |
INCRA Miter Gauges & Sleds
Precise cross cutting is just as important as accurate ripping. We offer INCRA miter gauges & crosscutting sleds for every application and budget!
|