INCRA LS32 Positioner Only
INCRA Metric LS32 Positioner Only
Click here to watch Guy Dunlap cuts Dovetails with the INCRA LS Positioner
Now available in metric!
As the largest fence positioner of the LS family, the LS32 was designed specifically for table saw use in conjunction with an INCRA TS Rail System.It's a direct replacement for the Ultra positioners used with the INCRA TS-II and TS-3A Fence Systems, and when equipped with the appropriate sub base, the LS32 can also serve as the foundation of a super-sized, custom router fence system.
Now available in both metric and imperial versions, the LS is the beefiest positioner we've ever produced, with rock-solid fence travels of 17", 430mm, 25", 32", or 810mm.Lifting the red locking lever causes the patented steel lead screw positioning system to instantly snap the fence to the dead center of any multiple of 1/32" or 1mm with an accuracy of 0.002" (0.05mm).This allows fence positioning far beyond what's possible by eyesight alone, and fence setups are instantly repeatable.The integrated micro adjust knob allows moving between whole increments with 0.001" (0.025mm) resolution for total control over small fence adjustments.
The lead screw adds quite a bit of mass, and because it's used for both incremental positioning and the micro adjust, the LS has fewer moving parts than the previous Ultra positioner.Other improvements include recessed, "big view" cursor windows, a large micro adjust knob conveniently located next to the fence, and all of the functions are now controlled by a single lever.And, quite simply, the sleek design is a handsome addition to any modern shop.
An engraved steel primary scale, Lexan secondary scale, and Auto Center Scale (imperial model only) are included standard.The steel fence mounting bracket accepts 1/4"-20 fasteners and is slotted vertically to accommodate several fence options and positioner installation heights.
The LS32 is directly compatible with the TS-3A rip fence extrusion when used with a table saw rail system, and is compatible with the Pro-II Joinery Fence and stand-alone Wonder Fence 37 when attached to a router table.
If you have an Ultra TS-III saw fence system purchased in 1999-2000 and the rip fence has only one T-slot in the front face and one T-slot in the rear face, it will be necessary to upgrade to the newer TS-IIIA fence extrusion to use an LS Positioner.Please call for details: 888.804.6272.
2. To mount the LS32 to a router table, the standard steel sub base under the tubular base housing must be replaced with the T-slotted aluminum sub base used on the LS17 & LS25 positioners. If you intend to attach the LS32 to a router table, please place your order by phone to ensure that your positioner is shipped with the appropriate sub base.
For more detailed information, check out the LS Positioner Owner's Manual.