 |
 |
 |
|
 
INCRA LS32 Positioner Only
INCRA Metric LS32 Positioner Only
Now available in metric!
As the largest fence positioner
of the LS family, the LS32 was designed specifically for table saw use in
conjunction with an INCRA TS Rail System.
It's a direct replacement for the Ultra positioners used with the INCRA
TS-II and TS-3A Fence Systems, and when equipped with the appropriate sub base,
the LS32 can also serve as the foundation of a super-sized, custom router fence
system.
Now available in both metric and imperial
versions, the LS is the beefiest positioner we've ever produced, with
rock-solid fence travels of 17", 430mm, 25", 32", or 810mm. Lifting the red locking lever causes the
patented steel lead screw positioning system to instantly snap the fence to the
dead center of any multiple of 1/32" or 1mm with an accuracy of 0.002"
(0.05mm). This allows fence positioning
far beyond what's possible by eyesight alone, and fence setups are instantly
repeatable. The integrated micro adjust
knob allows moving between whole increments with 0.001" (0.025mm) resolution
for total control over small fence adjustments.
The
lead screw adds quite a bit of mass, and because it's used for both incremental
positioning and the micro adjust, the LS has fewer moving parts than the
previous Ultra positioner. Other
improvements include recessed, "big view" cursor windows, a large
micro adjust knob conveniently located next to the fence, and all of the
functions are now controlled by a single lever.
And, quite simply, the sleek design is a handsome addition to any modern
shop.
An engraved steel primary
scale, Lexan secondary scale, and Auto Center Scale (imperial model only) are
included standard. The steel fence
mounting bracket accepts 1/4"-20 fasteners and is slotted vertically to
accommodate several fence options and positioner installation heights.
The
LS32 is directly compatible with the TS-3A rip fence extrusion when used with a
table saw rail system, and is compatible with the Pro-II Joinery Fence and
stand-alone Wonder Fence 37 when attached to a router table..Note:
1. If you have an Ultra TS-III saw fence system purchased
in 1999-2000 and the rip fence has only one T-slot in the front face and one
T-slot in the rear face, it will be necessary to upgrade to the newer TS-IIIA
fence extrusion to use an LS Positioner.
Please call for details: 888.804.6272. 2. To mount the LS32 to a router table, the standard steel sub base under the tubular base housing must be replaced with the T-slotted aluminum sub base used on the LS17 & LS25 positioners. If you intend to attach the LS32 to a router table, please place your order by phone to ensure that your positioner is shipped with the appropriate sub base.
For more detailed information, check out the LS Positioner Owner's Manual. |
|
|
|
|
|
|
|
|
