 |
 |
 |
|
The CleanSweep Cabinet easily attaches to the underside of every INCRA Router Table plus many other brands (see compatibility notes below).
The vacuum generated inside the cabinet by your 4" dust collection hose pulls chips and fine dust downward past the router bit, and the laser-cut CleanSweep Rings feature extra openings in strategic locations to dramatically increase dust-collecting downward airflow, keeping the table surface and your surrounding shop cleaner than you'd ever imagined.
Unlike a dust port mounted on the fence, the CleanSweep System works for every cut and not just when the fence is covering the router bit, giving you excellent collection even when routing grooves, making box joints & dovetails, or shaping curved edges without a fence.
This must-have accessory is one of the easiest ways to improve the quality of your router table time!
Porter-Cable Guide bushings and lock ring sold separately, order them here.
CleanSweep Compatibility:
- The CleanSweep Cabinet screws directly to the underside of laminated MDF and Phenolic Router Tables that have their bottom table opening and related hardware within the CleanSweep's 9-1/8" x 12-3/4" inside dimensions.
- The cabinet's maximum outside dimensions are 13" wide where the halves meet, 15" deep front to rear (parallel to the router plate's long edges), and 15-3/4" tall from the mounting flange to the end of the dust port.
- Kreg, Woodhaven, and laminated MDF tables from JessEm require the CleanSweep Table Adapter to clear the bottom-mounted leveling mechanism used at their table openings' corners.
- CleanSweep MagnaLOCK rings fit ONLY year 2006- or newer INCRA Router Plates and lifts that have a 3-5/8" opening through the bottom of the plate. These rings are NOT with INCRA Router Lifts or plates that have a 3-1/2" opening through the bottom of the plate.
- Dust Collection Systems that use hoses smaller than 4" are not recommended, and the CleanSweep Cabinet is not directly compatible with router tables that use remotely-operated router lifts.
Important:
The CleanSweep cabinet is intended for use only with conventional woodworking dust/chip collectors rated at 350 cfm or greater that have a minimum 4" inlet diameter. The CleanSweep is NOT compatible with typical Wet/Dry Shop Vacuums with 2-1/2” inlet diameters.
Questions? Call: 1.888.804.6272
|
|
|
 |
|
 |
|